© SAFLOK, all rights reserved.
INS_QTMIIMTRFID_2_12
QuantumII
TM
MT RFID Installation Instructions
Pg 4 of 8
Installing the lock trim
The outside lever trim has two carriage bolts that fit into the diagonal holes in the mortise case. These carriage bolts
establish an accurate trim position with respect to the mortise case assembly, allowing the levers and bolt mechanism
to operate without binding. The holes machined in the door surfaces should not influence the position of the trim or the
card reader assembly.
Do not tap or bend the carriage bolts to manipulate the fit of either trim piece during installation. The door prep holes
should accommodate the outside lever trim and the card reader assembly. If the carriage bolts or card reader enclosure
fit too tightly in the door prep holes, remove the mortise and enlarge the holes to achieve a free fit.
1. Remove the battery pack from the inside trim.
2. Position the outside proximity card reader assembly on
the outside of the door (see Fig. 4). Route the ribbon
cable and power cable through the 13/16” hole in
the door.
Do not pull on the ribbon cable. DO NOT
CREASE THE RIBBON CONNECTOR
3. Position the inside trim on the inside of the door.
4. Secure inside trim to the proximity card reader
assembly to the inside trim using three
M5 x 31 mm screws.
Important:
Do not fully tighten the screws at this point.
5. Align the outside lever trim with the diagonal holes
located on either side of the mortise hub and secure it
using the remaining two 8-32 x 1-1/4 screws (see Fig. 2).
Important:
Do not over tighten screws. If using a screw gun,
use a low torque setting.
6. Once the outside lever trim is fully secured, check the alignment of the
inside trim and be sure that the both levers rotate without binding. Once
the trim is properly aligned, fully tighten the screws that secure the proximity
reader assembly to the door and check for proper rotation.
7. Place the battery pack in position above the PCB. Be sure that the battery wire
is routed through the lower left corner of the battery compartment.
Note:
Do not plug in the battery until the other connections have been
made at the circuit board.
Proximity Reader
Assembly
Fig. 4
Inside Trim
Outside Lever
Trim
Ribbon Cable
8-32 x 1-1/4
Screws
8-32 x 1-1/4
Screws
Fig. 5
Route the ribbon
connector through the
rectangular hole
Motor Wire
Channels
