© SAFLOK, all rights reserved.
INS_QTMIIMTRFID_2_12
QuantumII
TM
MT RFID Installation Instructions
Pg 6 of 8
Installing the lock trim
(continued)
13. Secure the inside trim cover to the inside trim using two M4 x 16mm Torx screws (see Fig. 7).
14. Program the lock using the Lock Programmer and Interrogator (LPI) probe with the LPI-R device cable. Test the
functioning of the lock as discussed in the following section and in the programming manual before closing the door.
When the construction key is used, the green and red LEDs will blink together, indicating that the lock’s time and
date are not set.
15. For humid outdoor environments, apply dielectric grease inside the USB connector after programming to
guard against corrosion from persistent moisture.
Fig. 7
M4 x 16mm
Torx