Access Control - 1000 Series PBL FAQ
Note:
If your lock is opening on every turn of the knob or lever, except upon entering a code,
this may be a ZERO CODE. Before attempting to remove the lock from the door, refer to the
troubleshooting procedures outlined at bottom of this document for a zero code
symptom/solution.
1000 Series FAQ
Changing the Code / Combination
The door must be open.
On models with the passage feature, make sure the passage feature is disengaged: turn knob
or key should be in vertical position (A)
(see figure 1)
.
http://www.kaba-ilco.com/access_control/support/pbl_faq/changing_code_combination/1000_series.asp (1 of 3) [5/21/2004 11:13:59 AM]
