19
shipped with the lever sleeve already installed in
the lock housing. When installing the lever,
ensure it is oriented to engage the lever sleeve to
accommodate desired lock handing as shown.
I-2
Insert the outside lever (b) until it is flush to the
outside unit assembly (a). To secure the outside
lever, insert the release tool (d) (or screw driver)
into the outside lever as shown, and slide the lever
catch down until it clicks. Make certain lever is
attached before installing the core.
Note: For all interchangeable/removable cores
except ASSA/Medeco/Yale, proceed to section I-3.
For ASSA/Medeco/Yale cores, skip to section I-5.
I-3
Insert the supplied tailpiece (e) vertically into the
outside lever (b) as shown. Make certain that you
rotate the tailpiece so that it will align with the
interchangeable core. For screw cap type cores
(Schlage) (g), the tailpiece must be assembled
to the core first (vertical position). Insert the
interchangeable core into the outside lever.
Note: To remove the outside lever from the
outside unit assembly, follow the steps below.
I-4
Remove the interchangeable core (g).
Then remove the tailpiece (e).
Note: You may want to use needle nose pliers
for some tailpieces.
Insert the release tool (d) into the small hole (f)
under lever as shown. Gently push lever catch up
until it clicks. Remove tool, then remove outside
lever (b).
d
a
b
b
e
g
vertical
a
f
d
b
g
e
vertical
LIT1051_Simplex_506x _Mortise_1012.indd 19
1/7/13 3:13 PM
Summary of Contents for Simplex 506 Series
Page 1: ...Simplex 506x Mortise Installation Instructions ...
Page 15: ...15 Notes ...
