Kaba Simplex 506 Series, Installation Instructions Manual

21

J.  TESTING THE OPERATION OF THE LOCK

J-1

   Rotate in the inside lever downward and hold. Ensure that the latch is 

fully retracted. Release the lever and the latch should return to the fully 
extended position. With code entered, the lever only rotates downward.

J-2

   Enter the factory set combination: Depress buttons 2 and 4 at the same 

time (& release), then press button 3 (& release), then depress the 
“ENTER” button 

and release

. You should feel a slight click as each button 

is depressed.

J-3

   Rotate the outside lever downward and hold. Ensure that the latch is 

retracted sufficiently to clear the strike. Release the outside lever; the 
latch should be fully extended.

J-4

   Press the “ENTER” button only, and release, then rotate the outside 

lever. The latch should not retract.

J-5

   Insert one of the supplied keys into the outside lever. Rotate key coun-

ter clockwise until it stops (approximately 90 degrees), while holding 
the key in this position with one hand, use the other hand to rotate the 
lever downwards till it stops and hold (once the lever has rotated a few 
degrees the key may be released). Ensure that the latch has retracted 
sufficiently to clear the strike. Release the lever and ensure that the 
latch is fully extended.

K.  CHANGING COMBINATIONS

   Note: The factory set combination of your new 5000 series: Press “2” 

and “4” at the same time, then release. Press “3”, then release. Press 
the “ENTER” button, then release. For your security, the factory set 
combination MUST BE changed when lock is installed.

The combination can be easily changed using one to five of the lock’s buttons 
in any order in the combination. Each button can only be used once. 

Note: 

Three or more non-sequential button combinations are recommended for 
higher security.

 Also, two or more buttons may be pushed together (at the 

same time) as part of your new combination.

CAUTION: The door MUST BE open during this entire procedure.

   Note: The combination change can be done without removing lock 

from door. Ensure that the door is open during this procedure. Rotate 
the outside lever (d) once to stop position and release to reset the 
lock the latch should not retract.

K-1

 Press  the 

existing combination

 (b) followed by the 

ENTER

 button (c) 

and release; do 

not

 turn the lever.

LIT1051_Simplex_506x _Mortise_1012.indd   21

1/7/13   3:13 PM