Translation of the original operating manual for the KTS SpeedTec mini
B|HM0SM|00001|V0006|EN
Page
19
1.
Tape take-up mandrel with tape brake
The roll of adhesive tape is attached to the tape take-up mandrel by sliding it on laterally.
The tape pulling force can be adjusted via the tape brake.
2.
Electronic winding aid
This serves to reduce the tape pulling force during the taping process.
3.
Guide roller
The guide roller guides the adhesive tape.
4.
Guide roller (offset)
The guide roller guides the adhesive tape.
5.
Lower blade
This is used for the cutting of the tape upon completion of the taping process.
6.
Hold-down device (retaining blade)
The tape holder fixes the adhesive tape in place during the cutting process
7.
Upper blade
This is used for the cutting of the tape upon completion of the taping process.
8.
End-of-tape sensor
This sensor detects when the roll of tape has been used up and a new roll of tape has to
be fitted.
9.
Hold-down device (positioning mechanism)
The tape holder fixes the adhesive tape in place.
10.
Positioning finger
This is used to set the adhesive tape in the correct position.
