Translation of the original operating manual for the KTS SpeedTec mini
B|HM0SM|00001|V0006|EN
Page
51
Maintenance and servicing
6.
Danger
Do not perform maintenance and servicing tasks until the device has been
switched off and the supply of power and the supply of compressed air have
been interrupted.
6.1 Maintenance schedule for three-shift operation
The maintenance and servicing schedule specified below should be complied with. The schedule
is geared towards 7-day, three-shift operation. If there is a different work arrangement, the
maintenance and servicing schedule may have to be adapted accordingly.
Daily
Weekly
monthly
Half-yearly
As needed
6.2 Check guides/carriages
X
6.2 Lubricate guides/carriages
X
6.3 Cleaning the cutter and hold-
down device
X
6.5 Oiling the cutter
X
6.6 Checking/Cleaning the safety
light barriers
According to manufacturer’s specifications
6.7 Cleaning the air filter
X
6.8 Cleaning the Makrolon discs
X
6.9 Setting the end-of-tape
sensor
X
6.10 Check/Cleaning the guide
rollers
X
6.11 Cleaning the taping-unit
carriage guide
X
6.12 Greasing the bearings
X
6.13 Cleaning the positioning
finger
X
6.14 Checking/Changing the
belts
X
X
6.14 Perform tensile force
calibration
X
