step 1
step 2
step 3
step 4
Then follow the
instructions to fit
your doors and
panels.
Finish off your
Kaboodle Kitchen
by installing your
benchtop.
Next grab your
parts and
accessories
instructions.
Your Kaboodle
cabinet is now
complete.
st
ep 1
p.
4
Ver. 9
W-70106
We offer a dedicated customer service line
for advice or any questions you may have
on kaboodle products.
Call customer service on:
Australia:
1800 666 078
Monday to Friday between
8.00am and 6.00pm AEST
New Zealand:
0800 522 663
Monday to Friday
between 8.00am and 5.00pm NZST or email:
info@kaboodlegroup.com.au
Caring for your kaboodle cabinets
Looking after your cabinets is really easy and with the right care and maintenance they
will last you for many years. Just follow these simple steps and if you need any more
information you can contact us: Australia:
1800 666 078
Monday to Friday between
8:00am and 6:00pm AEST. New Zealand:
0800 522 663
Monday to Friday between
8:00am and 5:00pm NZST or email:
info@kaboodlegroup.com.au
.
Clean your cabinets with an all purpose, non-abrasive cleaner with a damp sponge or
cloth and make sure you never use saturated cloth, harsh chemicals or thinner based
cleaners as these will damage the surface of the melamine. Likewise, never use products
that will scratch the surface like steel wool or wire brushes and avoid sharp objects that
will scratch, cut or gouge the melamine surface. If this happens the internal board will be
exposed and may swell. Kaboodle cabinets are water resistant but not water proof so any
spills should be attended to immediately.
Handy hint:
if the melamine surface of your cabinet is damaged you can try and cover it
with a furniture repair crayon but just remember that this won’t seal the board back to its
original finish.
important information
NOTE:
Some handles in certain configurations
can collide with each other when doors are
open, potentially causing the blind corner
cabinet doors to not open wide enough to
access the pantry.
Test your chosen handles before installing
and if you find that this is the case you will
need to either adjust the positions of the
handles, choose different handles, or use
push to open mechanisms without any
handles.
Alternately you can move your entire blind
corner cabinet away from the wall 50mm*
so that the blind corner panel sits out from
the adjoining cabinet by 90mm rather than
40, leaving room for the handles to open.
When the benchtop is installed you will not
be able to see the gap between the cabinet
and wall.
1000mm
blind corner base cabinet
KBNZ_Kit_W-70110_1000_blind_cnr_BC-V9 2.indd 4
25/01/2017 3:56 PM
