K A B T R O N I C S A S S E M B L Y I N S T R U C T I O N S
World Clock Kit Page 10
( ) load the two red LEDs between the displays as shown above.
The shorter lead goes in the hole near the flat part of the outline, closer to the bottom edge. Try
to have the top of the LED even with the height of the display.
( ) load the 14 alphanumeric displays one at a time. These also have a decimal point that should
go toward the lower edge. Push these against the board while you solder the leads, and be careful
again about over heating the leads.
( ) load the 16 transistors as shown below.
Summary of Contents for World Clock
