Kabuto AERO-R1, Instruction Manual

CAUTION!

Mounting part

XF-7 Adjuster

XF-7 Adjuster

Fig. 1

Hold the XF-7 Adjuster around the mounting part firmly 
and move it up and down among the three positions as 
illustrated (Fig.1, Fig.2.) The fourth hole is for 
detaching the XF-7 Adjuster (Fig.2).
In adjustment, move the XF-7 Adjuster slowly to avoid 
from accidental detachment.

Setting the XF-7 Adjuster Position

Detach/Attach the XF-7 Adjuster

In adjustment, never fail to hold the mounting part. 
Twisting forcefully moving the XF-7 Adjuster may 
cause its breakage. Please pay due caution in 
adjustment.

Detach

Hold firmly the XF-7 Adjuster around the mounting 
part, move it to the fourth hole position, and twist it 
either right or left a little as illustrated (Fig.3.) Be 
reminded that moving the mounting part past third slit 
to the fourth hole gets a little tighter. Then, hold around 
the arm fixing base portion, pull the XF-7 Adjuster 
slowly to detach the mounting part.

Attach

Place the thumb between the mounting part and the 
inner surface of the shell and lift it a little as illustrated 
in Fig.4.  Align the XF-7 Adjuster fourth hole with the 
bump on the mounting part, press the XF-7 Adjuster 
hard and slide it down. Press the bump on the tip of 
the XF-7 adjuster arm 
into the fixing hole 
(basket) on each 
side.
After mounting the 
XF-7 adjuster, make 
sure the chinstrap 
relative position to the 
XF-7 adjuster as 
illustrated in Fig.5

❶

❷

❸

The fourth hole

Adjustable at

3 angles 

Fig. 2

Fig. 3

Move the 

mounting hole to 

the fourth hole 

position and 

twist a little.

Chinstrap

Mounting part

bump

Fig. 4

Fig. 5

XF-7

Adjuster

XF-7 Adjuster

Place the

thumb under

the part

and lift the

Adjuster a

little.     

Let the chinstrap go
through the XF-7 adjuster 
a illustrated.

17