Kabuto Japan IBUKI, Instruction Manual

ENG

.

3. Make sure if the overall silicon seal of the Pinlock

®

 Original Insert Lens is 

attached firmly to the shield by mounting the shield on the helmet. If there is any 

space between them, refer to “How to Adjust Pinlock

®

 Original Insert Lens after 

Attachment” and adjust the lens. 

4. Peel off the protective film on the Pinlock

®

 Original Insert Lens.

1. Remove the shield from the helmet. 

2. Remove the Pinlock

®

 Original Insert Lens from 

the eccentric pins with flexing the shield. (Fig.6)

* Please read carefully the “CAUTION” and the “CAUTION *Pinlock

®

 Original Insert Lens”.

Adjust the Pinlock

®

 Original Insert Lens if there 

is any space between the lens and the shield.

1. Remove the shield from the helmet and 

detach the Pinlock

®

 Original Insert lens from 

the shield.

2. Adjust the eccentric pins by turning them with 

a tool. (Fig. 7)

3. Fit the Pinlock

®

 Original Insert Lens back on 

the shield. Make sure the Pinlock® Original 

Insert Lens and the shield do not have any 

space in-between after attaching the shield on 

the helmet. If there is any space please follow 

the same steps again.

*Please mount the shield on the helmet when checking if the Pinlock

®

 Original Insert Lens is attached firmly to 

the shield. Otherwise, the shield might be spread out by the pressure from the lens and it cannot be assured if 

the lens has attached on the shield firmly.

[How to Remove Pinlock

®

 Original Insert Lens]

[How to Adjust Pinlock

®

 Original Insert   

Lens after Attachment]

Fig.5

Fig.6

Fig.7

Section view

of shield:

Protective film

Pinlock® Original 

Insert Lens

Silicon seal

Silicon seal

Shield

Eccentric pin

Eccentric pin

Correct

Wrong

Shield

Face the eccentric pins inwards

Face the eccentric pins outwards

Pinlock® Original Insert Lens will be loose.

Pinlock

®

 Original Insert Lens will be pushed out and there would not be 

any space between the Pinlock

®

 Original Insert Lens and the shield.

Eccentric pins

*with no space

Make sure the Pinlock

®

 Original Insert Lens to 

be fit inside the chase.

Facing the eccentric 

pins inwards

Facing the eccentric 

pins outwards

Loosening the Pinlock

®

Original Insert Lens

Pinlock

®

 Original Insert Lens is pushed out 

and will be in close contact with the shield.

ENG-12