Page
16
hy-switch for KACO blueplanet hybrid inverters
7.
Assembly and preparation
7.1.
Unpacking the component
CAUTION
Property damage as a result of condensation!
Faulty storage can form condensate in the component and impair
its function (e.g., storage outside the ambient conditions or
a brief change of location from a cold to a hot environment).
1.
Open the packaging carefully. Be careful not to damage the component
when using sharp objects.
2.
Remove the operating instructions and installation bag
3.
Remove the component from the packaging.
4.
Place the protective packaging back into the carton.
» Continue installing the component.
7.2.
Install the component
Choosing the installation location
Place the blueplanet hy-switch near the control cabinet or energy sub-distributor.
Observe the environmental data under 5.2.
When mounting, keep a distance of at least 15 cm to all sides. The additional space
required for the connection area of the AC cables below the hy-switch must be
provided. Observe the permissible bending radii of the cables.
NOTE
Access by maintenance personnel for service
Any additional costs arising from unfavourable structural or
mounting conditions shall be billed to the customer.
