28
| Kaden Installation Manual
9. Panel installation
CAUTION
Do not
place the panel face down on the floor, against a
wall, or on uneven surfaces.
KCI
models
Step 1: Remove the front grille.
1. Push both of the tabs towards the middle simultaneously to
unlock the hook on the grille.
2. Hold the grille at a 45° angle, lift it up slightly and detach it
from the main body.
Step 2: Remove the installation covers at the four corners
by sliding them outwards.
Step 3: Install the panel
Align the front panel to the main body, taking into account the
position of the piping and drain sides. Hang the four latches of
the decorative panel to the hooks of the indoor unit. Tighten the
panel hook screws evenly at the four corners.
NOTE:
Tighten the screws until the thickness of the
sponge between the main body and the panel reduces to
4 – 6mm. The edge of the panel should be in contact with
the ceiling well.
Adjust the panel by turning it to the arrowed direction so that
the ceiling opening is completely covered.
1. Connect the two louvre motor connectors to the
corresponding wires in the control box.
2. Remove foam stops from inside the fan.
3. Attach the side of the front grille to the panel.
4. Connect the display panel cable to the corresponding wire
on the main body.
5. Close the front grille.
6. Fasten the installation covers at all four corners by pushing
them inwards.
Drain side
Latch
Screwdriver
Piping side
Control box
Connect the
louvre motor
Connect the
louvre motor
Grille screw cover
Remove the grill screws
Grille switch
