16
| Kaden Installation Manual
Step 2: Install drain joint
Before bolting the outdoor unit in place, you must install the
drain joint at the bottom of the unit. Note that there are two
different types of drain joints depending on the type of
outdoor unit.
If the drain joint comes with a rubber seal (see Fig. A),
do the following:
1. Fit the rubber seal on the end of the drain joint that will
connect to the outdoor unit.
2. Insert the drain joint into the hole in the base pan
of the unit.
3. Rotate the drain joint 90° until it clicks in place facing the
front of the unit.
4. Connect a drain hose extension (not included) to the drain
joint to redirect water from the unit during heating mode.
If the drain joint doesn’t come with a rubber seal
(see Fig. B), do the following:
1. Insert the drain joint into the hole in the base pan of the
unit. The drain joint will click in place.
2. Connect a drain hose extension (not included) to the drain
joint to redirect water from the unit during heating mode.
IN COLD CLIMATES
In cold climates, make sure that the drain hose is as
vertical as possible to ensure swift water drainage.
If water drains too slowly, it can freeze in the hose and
flood the unit.
Step 3: Anchor outdoor unit
The outdoor unit can be anchored to the ground or to a wall-
mounted bracket with bolt (M10). Prepare the installation base
of the unit according to the dimensions below.
Unit mounting dimensions
The following is a list of different outdoor unit sizes and the
distance between their mounting feet. Prepare the installation
base of the unit according to the dimensions below.
Outdoor unit types and specifications
Split type outdoor unit
Base pan hole
of outdoor unit
Seal
Drain joint
Seal
Fig. A
Fig. B
H
H
B
D
W
W
A
