Fault
code
Meaning
Action
14
Fault in communication with motor.
Call KAESER SERVICE.
15
Permissible peak current exceeded.
Call KAESER SERVICE.
16
Below minimum speed.
Call KAESER SERVICE.
17
Fault - venting and condensate valve.
Call KAESER SERVICE.
Tab. 20 Fault messages
Warning display
Warnings are only displayed when the machine is switched on.
When a warning occurs, the LED
ON in the display illuminates yellow (item 7, see chapter 4.5) as
long as the warning is applicable.
Display the corresponding warning for 5 seconds by simultaneously pressing the «UP»
and «DOWN» keys.
The warning code of the currently applicable or the last warning since the mains voltage has last
been applied is displayed in the warning display.
If no warning is applicable two dashes are displayed.
Warning display Meaning
Action
u
Mains voltage too low.
Check the mains supply.
p
Power demand too high.
Call KAESER SERVICE.
t
Temperature in the motor drive too high.
Reduce the ambient temperature.
Check cooling air supply.
b
Speed target/actual deviation.
Call KAESER SERVICE.
Tab. 21 Warning display
9
Fault Recognition and Rectification
9.2
Fault messages (machine shut down)
No.: 901731 24E
Operator manual Reciprocating compressor
i.Comp 3
39
Summary of Contents for i.Comp 3
Page 2: ...Original instructions KKW PWPC 2 04 en SBA KOLBEN ANLAGE M 20200310 081012...
Page 6: ...Contents iv Operator manual Reciprocating compressor i Comp 3 No 901731 24E...
Page 8: ...List of Illustrations vi Operator manual Reciprocating compressor i Comp 3 No 901731 24E...
Page 10: ...List of Tables viii Operator manual Reciprocating compressor i Comp 3 No 901731 24E...
