5. Open the outlet valves.
6. Open the right-hand access door.
7. Visually check the fuel system for leaks.
8. If necessary, re-tighten the screw connections.
9. Close the door.
10.4.4 Checking the engine oil level
The oil level can be read from a dipstick at the oil pan. The oil level should ideally be between the
two marks on the dipstick. The oil level should not be allowed to fall below the
minimum level.
Material Cleaning cloth
Precondition The machine is switched off.
The engine has cooled down.
The machine is standing level.
Air consumers are disconnected,
the outlet valves are open,
the machine is fully vented, the pressure gauge reads 0 psig.
«Controller ON/OFF» switch is switched off,
the minus cable of the battery has been disconnected.
Fig. 40 Checking the engine oil level
1
Engine
2
Oil filler neck cover, engine oil
3
Dip-stick
4
Upper mark for
maximum oil level
5
Lower mark for
minimum oil level
6
Correct range for oil level
1. Open the door.
2. Pull out the dipstick.
3. Wipe with a clean lint-free cloth.
4. Push in the dipstick.
10 Maintenance
10.4 Drive engine maintenance
No.: 902366 10 USE
Operator Manual Portable Rotary Screw Compressor
MOBILAIR M55 PE SIGMA CONTROL SMART pV
115
