Fig. 41 Draining the engine oil
1
Drive engine oil pan
2
Oil filler neck cover, engine oil
3
Hose coupling
4
Male hose coupling
1. Open the left-hand door.
2. Loosen and remove the oil filler cover.
3. Position a receptacle beneath the oil pan (hole in the floor panel).
4. Suspend and fasten the free end of the hose in the receptacle.
5. Loosen and remove the protective cap for the hose coupling.
6. Install male hose coupling on the hose coupling.
Engine oil drains.
Draining the engine oil
➤ Allow the oil to drain out.
Dispose of old oil and oil-soaked working materials according to environmental protection
regulations.
Close the hose coupling of the engine
1. Loosen and remove the male hose coupling.
The hose coupling is closed.
2. Additionally close the hose coupling with the protective cap.
Further information See chapter 10.4.5 for filling with fresh engine oil.
10.4.7 Replacing the engine oil filter
Standard tools, such as filter wrench or belts may be used in order to loosen the old oil filter
for removal. The new oil filter, however, may only be installed and tightened by hand force.
10 Maintenance
10.4 Drive engine maintenance
118
Operator Manual Portable Rotary Screw Compressor
MOBILAIR M55 PE SIGMA CONTROL SMART pV
No.: 902366 10 USE
