➤ Do not use a corrosion inhibitor/antifreeze that has not been approved by the engine manufac‐
turer.
➤ Avoid impermissible mixing ratios of corrosion inhibitor/antifreeze and water.
Further information For information regarding the preparation/mixing of the coolant, please see chapter 10.4.1.3 “Mix‐
ing the Coolant”.
Initial fill of corrosion inhibitor/antifreeze:
For the initial fill, the coolant cooler is filled with a mixture of the following fluid components:
Components
Description
Percentages [% vol.]
Corrosion inhibitor/antifreeze KAESER FLUID ENGINE ANTIFREEZE /
(Glysantin
®
G40
®
)
50
Water
50
Tab. 33 Initial fill of coolant cooler
Miscibility with other corrosion inhibitors/antifreezes:
Mixing with different corrosion inhibitors/antifreezes is not recommended, even if from the same
manufacturer. This can result in significantly reduced corrosion/antifreeze protection, which may
damage the engine cooling system and, consequently, the engine. A mixtures of different types of
anti-corrosion agent/antifreeze generally provides a lower level of performance than the specially
balanced active components of a single coolant type.
Consequently, the use of different corrosion inhibitors/antifreezes is only permitted following
consultation with and approval from the engine manufacturer!
2.8.5 Fluid volumes
Description
Fluid volume [gal]
Engine oil
1.8
Fuel
21.1
Coolant
2.8
Tab. 34 Fluid volumes
2.8.6 Batteries
Feature
Value
Voltage [V]
12
Capacity [Ah]
80
PTC testing current [A]
(according to EN 50342)
680
Tab. 35 Batteries
2
Technical Data
2.8
Engine
No.: 902366 10 USE
Operator Manual Portable Rotary Screw Compressor
MOBILAIR M55 PE SIGMA CONTROL SMART pV
17
