Material Spare part
Cleaning cloths
Wrench
Precondition The machine is switched off.
The machine is fully vented, the pressure gauge reads 0 psig.
The machine has cooled down.
All compressed air consumers are disconnected and the air outlet valves are open.
The «battery isolating switch» is turned off.
➤ Open the access door and remove the left-front panel.
10.6.6.1 Changing the oil separator cartridge
Fig. 62 Changing the oil separator cartridge
1
Control air line union nut
2
Oil scavenge pipe (screwed to the cover)
3
Oil scavenge pipe union nut (screwed to
the dirt trap)
5
Air pipe
6
Pipe fitting
7
Cover
8
Fastening screw
9
Control valve
10
Solenoid valve plug
11
Gasket
12
Metal clip
13
Oil separator cartridge
1. Unscrew the union nuts
1
and
3
and place the components with connections carefully to one
side.
2. Pull out the plug to the solenoid valve
10
and withdraw the cable.
3. Unscrew the fitting
6
and turn the air pipe
5
to one side.
4. Remove the screws
8
securing the cover
7
of the oil separator tank.
5. Carefully lift the cover and put to one side.
Take care that the oil scavenge pipe
2
screwed to the underside of the cover is not bent in
the process.
10 Maintenance
10.6 Compressor Maintenance
No.: 901779 08 USE
Operator Manual Portable Rotary Screw Compressor
MOBILAIR M58utility SIGMA CONTROL SMART
139