7. Use «Up» or «Down» to select the
IP address line.
8. Press «Enter».
The setting mode is active.
9. Set the IP address of the communication partner (master, see above example).
10. Press «Enter».
The IP address of machine 1 (master) is set correctly.
Setting the load balancing
➤ Setting the load balancing (see chapter 8.7.4.5).
Activating the remote control
➤ Activate remote control see chapter 8.2.13.
Result The remote control is activated.
The controller of machine 2 is set as slave.
8.7.4.4 Switching on both machines
➤ Press «ON» on both machines.
The
on LED lights green on both machines.
8.7.4.5 Load balancing
You can optionally set load balancing for both machines. Without load balancing being active, the
machines will operate in fault-actuated changeover mode (redundancy operation).
Load balancing is activated only on machine 1 (master).
Setting load balancing for machines 1 and 2
1. Open the 4.2
<Maintenance – Load balancing> menu.
2. Use «Up» or «Down» to select the
Load balancing line.
4 0 0 m b a r
0 8 : 1 5 A M
8 0 ° C
Header
4.2 Load balancing
Load balancing
☐
Active line with inactive check box
dt maintenance hours
5h
Maintenance Master
1h
Maintenance Slave
1h
Master state
ready
Slave state
ready
8
Initial Start-up
8.7
Setting the machine for master control operation
No.: 901700 14 E
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 4.0.X
121
