4. Press «Enter».
The setting is applied.
5. Press «Escape» repeatedly to leave this menu.
Result The «Time control» key is activated.
8.5.1.4 Activating time control
Precondition The «Time control» key is activated; see chapter 8.5.1.3.
➤ Press the «Time control» key on the SIGMA CONTROL 2 operating panel to activate the time
control.
Result The
Time control LED on the operating panel of the SIGMA CONTROL 2 signalises with green
continuous light that the machine is operated with activated time control.
The time control of SIGMA CONTROL 2 switches the machine according to the defined switching
points of the time program.
8.5.2 Automatic start/stop with timer
You can use the timer for the machine cutting in and out between LOAD and READY. Valid setting
values for the cutting in and out duration are between 24 h ≥ t ≥ 15 m.
Precondition Access level 2 is activated.
1. Open the 5.9
<Configuration – Pulse generator> menu.
4 0 0 m b a r
0 8 : 1 5 A M
8 0 ° C
Header
5.9 Pulse generator
Menu
Activate
☐
The timer is deactivated
on :
00h:00m:00s
Cut-in period
off :
00h:00m:00s
Cut-out period
Function
Load
Mode
2. Use «Up» or «Down» to select the
on line.
3. Press «Enter».
The setting mode is active.
The display for hours
00h:00m:00s flashes.
4. Use «Up» or «Down» to set the hours.
5. Press the «Right» key.
The display for minutes
01h:00m:00s flashes.
6. Use «Up» or «Down» to set the minutes.
7. Press the «Right» key.
The display for seconds
01h:15m:00s flashes.
8. Use «Up» or «Down» to set the seconds.
9. Press «Enter».
The setting is applied.
10. Use «Up» or «Down» to select the
off line.
8
Initial Start-up
8.5
Machine start and machine stop
No.: 901700 14 E
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 4.0.X
85
