Fig. 15 Logging in manually
4. Use the «Up» or «Down» key to select the desired character.
5. Press the «Right» key.
The cursor jumps to the next character in the username.
6. Enter the remaining characters for the username in the same way.
7. Press the «Enter» key.
The username has been entered.
8. Using the «Up» or «Down» key, select the line
Password.
9. Press the «Enter» key.
Enter the letters and digits for the password in the same way.
Please note that password entry is case sensitive!
10. Press the «Enter» key.
The password has been entered.
11. Use the «Up» or «Down» key to select the
[Login] line.
12. Press the «Enter» key.
Current access level 2 is displayed.
Result You are now logged in to the SIGMA CONTROL 2 with access level 2, via manual input of your
username and password.
8.2.7 Setting up the master RFID Equipment Card
If you are using the SIGMA CONTROL 2 controller to operate multiple KAESER machines, it may
be a good idea to create a master RFID Equipment Card with which you can log into all of the ma‐
chines.
Precondition The RFID Equipment Card supplied with the machine and at least one additional teachable master
RFID Equipment Card are available
The operating display is shown
8
Initial Start-up
8.2
Setting the controller
54
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 4.0.X
No.: 901700 14 E
