8.5.1.2 Setting the clock program (example)
When setting a clock programme for the first time, note first the switching times on the "User-
defined clock programme" table for example.
In addition to individual weekdays, the controller has the following cycles:
■ Mon-Thu
■ Mon-Fri
■ Mon-Sat
■ Mon-Sun
■ Sat-Thu
■ Sun-Thu
Example
■ Machine ON: On weekdays 06:30AM – 05:00PM, Fridays 06:30AM – 03:00PM
■ Machine OFF: Sat – Sun and during midday break 12:00PM – 01:00PM
The following switching points result:
No.:
Day
Time
Function
01
Mon-Fri
06:30AM
on
02
Mon-Fri
12:00PM
off
03
Mon-Fri
01:00PM
on
04
Mon-Thu
05:00PM
off
05
Fri
03:00PM
off
Tab. 63 Example of a machine ON/OFF clock program
Precondition Access level 2 is activated.
1. Open the 6
<Time control> menu.
2. Use «Up» or «Down» to select the
01 line.
4 0 0 m b a r
0 8 : 1 5 A M
8 0 ° C
Header
6 Time control
Menu
······························
01
n.a.
00:00AM
off
Active line with switching point 01
02
n.a.
00:00AM
off
Switching point 02
03
n.a.
00:00AM
off
Switching point 03
04
n.a.
00:00AM
off
Switching point 04
05
n.a.
00:00AM
off
Switching point 05
3. Press «Enter».
The
n.a. indication flashes.
4. Use «Up» or «Down» to set the weekdays.
5. Press the «Enter» key.
The setting is applied.
6. Press the «Right» key.
8
Initial Start-up
8.5
Machine start and machine stop
No.: 901700 14 E
Service Manual Controller
SIGMA CONTROL 2 BLOWER ≥ 4.0.X
83
