Fig. 87 Ball coupling (ALKO-USA)
1
Coupling handle
2
Ball coupling
3
Towing vehicle ball hitch
4
Safety pin
5
Fixing hole for the security pin
6
Ball coupling properly secured
1.
There is considerable danger of injury caused by trapped fingers.
They can be trapped in the spring-loaded closing mechanism.
➤ Never place your fingers inside an open ball coupling.
➤ Always wear protective gloves.
2. Check if the security pin is removed from the coupling and draw it out if not.
3. Pull up the coupling handle.
The coupling opens.
4.
Risk of accident due to unhitching of the ball coupling during transport.
If the coupling is not fully closed the compressor can become uncoupled from the towing vehi‐
cle and cause an accident.
➤ Check correct coupling.
➤ Check correct location of the security pin.
5. Place the open coupling over the towing vehicle ball hitch.
The weight on the coupling will cause it to audibly close. The coupling locks automatically.
Closing and locking is automatic.
6. Push the handle down to be certain of locking.
The coupling is fully locked when the handle is fully down and can be pushed no further.
7. Insert the security pin in the ball coupling fixing opening.
12.2.2.3 Ensure transport readiness of the coupled machine.
Fig. 88 Release the parking brake.
a
Parking brake with gas spring assistance
1
Parking brake lever
2
Marking: “Dead point zone”
b
Parking brake with ratchet and spring load‐
ing
3
Brake lever release button
12 Decommissioning, Storage and Transport
12.2 Transport
No.: 901765 05 USE
Operator Manual Screw Compressor
M114 SIGMA CONTROL SMART
231
