7.2.2 Special measures for recommissioning after storage
➤ Carry out the following before every start-up after long period of storage:
Storage
period longer
than:
Remedy
5 months
➤ Remove the desiccant from the openings in the air intake filters of the engine
and compressor.
➤ Check the air and oil filters.
➤ Drain the preserving oil from the separator tank.
➤ Fill with cooling oil.
➤ Drain the preserving oil from the engine.
➤ Fill with engine oil.
➤ Check the engine coolant
➤ Check the battery charge.
➤ Re-connect the battery (batteries).
➤ Check all fuel lines, engine oil lines and compressor cooling oil lines for leaks,
loose connections, wear and damage.
➤ Clean the bodywork with a grease and dirt dissolving agent.
➤ Check the tire pressures.
36 months
➤ Have the overall technical condition checked by an authorized KAESER service
representative.
Tab. 51 Measures for recommissioning the compressor after a long period of storage
7.3 Checking installation and operating conditions
➤ Check and confirm all the items in the checklist before starting the machine.
Check
See chapter Confirmed?
➤ Are the operators fully conversant with safety regulations?
–
➤ Have all the positioning conditions been fulfilled?
➤ Is there sufficient cooling oil in the separator tank?
➤ Is there sufficient oil in the engine?
➤ Is the maintenance indicator on the air intake filters (engine and
compressor) OK?
➤ Is there sufficient coolant in the coolant expansion tank?
➤ Is there sufficient fuel in the fuel tank?
–
➤ Is there sufficient tool oil in the tool lubricator? (option ea, ec)
➤ Are the access doors closed and all body panels in place?
–
➤ Are the tire pressures OK?
–
Tab. 52 Positioning and operating conditions checklist
7
Initial Start-up
7.3
Checking installation and operating conditions
No.: 901765 05 USE
Operator Manual Screw Compressor
M114 SIGMA CONTROL SMART
67
