Additional precautions for snow and ice:
Significant snow or ice build-up can occur on the machine when operating in winter conditions.
This may adversely affect the machine's centre of gravity (tilting).
This may cause the permissible load of the crane and machine hoists to be exceeded.
➤ Carry out the following preliminary tasks in conditions of snow and ice:
■ Remove any snow and/or ice from the machine before lifting by crane.
■ Make sure the lifting eye cover plate is freely accessible and can be opened.
Perform the following tasks prior to moving the machine by crane:
A lifting eye is provided for transportation by crane. The lifting eye is located beneath a lift-up cover
plate in the centre of the enclosure.
Risk of falling!
For mobile machines, climbing aids (steps) must be used to safely reach the crane lifting
eye!
Wear clean safety footwear!
Climbing onto the roof of the machine is prohibited!
1.
Hot components in the machine interior!
➤ Allow the machine to cool down sufficiently.
2.
Damage to the machine from jolting during lifting!
Danger of components breaking.
➤ Lift the machine carefully.
3. Open one of the two doors.
4. Unlock the cover from the inside by actuating the built-in hand lever and lift up.
5. Close the door.
6. Position the crane hook vertically above the lifting eye.
7. Engage the crane hook in the eye.
8. Close and lock the access doors.
9. Lift and move the machine slowly and carefully.
Take note when setting down the machine:
1.
Incorrect setting down can damage the machine!
Machine components, particularly the chassis, can be damaged by incorrectly setting down the
machine.
➤ Set the machine down carefully.
➤ Do not set down unevenly.
2. Set the machine down slowly and carefully.
1. Disengage the crane hook.
2. Press the lifting eye cover down and close. Make sure it locks into place.
12 Decommissioning, Storage and Transport
12.2 Transport
254
Operator Manual Portable Rotary Screw Compressor
MOBILAIR M82 SIGMA CONTROL SMART
No.: 901783 08 USE
