Fig. 29 Hose reel (EC design)
1
Winding handle (fold out)
2
Hose reel
3
Hose
4
Hose coupling
5
Securing holes
6
Hose reel side plate
7
Clamping screw
8
Transport securing bolt
8.4.1.1 Operating the machine with an extension air hose.
1. Loosen the transport securing pin
8
and the clamping screw
7
.
2. Fold out the crank handle
1
and reel out the required length of hose
3
.
3. Tighten the clamping knob.
The reel is locked against unwanted reeling in or out.
4. Fold in the handle.
5. Connect the air tool.
6. Activate the machine.
7. Open the compressed air shut-off valve.
8.4.1.2 Operating the machine without an extension air hose.
1. Close the compressed air shut-off valve.
2. Disconnect the air consumer.
3. Fold out the winding handle
1
and reel in the hose
3
firmly and evenly.
4. Tighten the clamping screw
7
.
The reel is locked against unwanted reeling in or out.
5. Fold in the handle.
8.4.1.3 Securing the hose reel for transport
1. Check that the hose is firmly and evenly reeled in. Reel again, if necessary.
2. Locate the securing hole
8
in the reel's side plate
5
until it is aligned with the securing
screw
2
.
3. Screw in the securing bolt fully.
4. Tighten the clamping screw
7
.
8
Operation
8.4
Using the hose reel
No.: 9_5898 26 E
Operator manual Portable compressor
M 64
75
RAMIRENT
