4. Mount the micro-filter cartridges on the filter mount:
■ Moisten the rubber seals of the filter mount and the sealing faces of the new filter cartridge
with some fuel.
■ Manually screw the filter cartridge to the filter head (clockwise), until seal is tight.
5. Reconnect the battery.
6. Close the door.
The fuel system must be bled after the filter cartridges have been changed.
Dispose of fuel and any materials and components contaminated with it in accordance with
environmental protection regulations.
Starting the machine and performing a test run:
1. Switch the machine on and run it in IDLE mode for approx. 1 minute.
2. Shut down the machine.
3. Open the right-hand access door.
4. Visually check the fuel system for leaks.
5. Tighten all fittings.
6. Close the door.
10.3.4 Checking the engine oil level
The engine oil is indicated by a dipstick in the oil sump. The oil level should ideally be between the
two marks on the dipstick. The oil level should not be allowed to fall below the
minimum level.
Material Cleaning cloth
Precondition The machine is shut down.
The machine is standing level.
The machine is fully vented, the pressure gauge reads 0 bar.
Engine cooled down.
All compressed air consumers are disconnected and the air outlet valves are open.
10 Maintenance
10.3 Engine maintenance
No.: 9_5898 26 E
Operator manual Portable compressor
M 64
109
RAMIRENT
