3. Wait 5 minutes then check the oil level.
It takes a few minutes for oil to reach the sump.
Top up if the level is too low.
4. Replace the plug in the filler port.
5. Reconnect the negative battery terminal.
6. Close the door.
Starting the machine and performing a test run:
1. Switch the machine on and run it in IDLE mode for approx. 5 minutes.
2. Shut down the machine.
3. Wait until the machine has automatically vented.
Pressure gauge reads 0 bar.
4. Open the right-hand access door.
5. Check the oil level after about 5 minutes.
Top up if the level is too low.
6. Visually inspect for leaks.
7. Close the door.
10.3.6 Changing the engine oil
The engine oil should be changed:
■ according to the maintenance schedule,
■ according to the degree of contamination of the intake air,
■ at least once a year.
Material Engine oil
Oil receptacle
Wrench
Cleaning cloths
Precondition The machine is switched off.
The machine is standing level.
The machine is fully vented, the pressure gauge reads 0 bar.
Engine at operating temperature.
All compressed air consumers are disconnected and the air outlet valves are open.
The negative cable to the battery is disconnected.
CAUTION
Danger of burns from hot components and escaping motor oil!
➤ Wear long-sleeved clothing and gloves.
Draining the engine oil
The oil is drained directly at the engine's oil pan. For this purpose, a drainage outlet is provided in
the floor pan.
10 Maintenance
10.3 Engine maintenance
No.: 9_5898 26 E
Operator manual Portable compressor
M 64
111
RAMIRENT
