10.3.7 Replace the engine oil filter
Material Spare part
Filter wrench
Cleaning cloths
Oil receptacle
Precondition The machine is switched off.
The machine is fully vented, the pressure gauge reads 0 bar.
Engine cooled down.
All compressed air consumers are disconnected and the air outlet valves are open.
The negative cable to the battery is disconnected.
CAUTION
Danger of burns from hot components and escaping motor oil!
➤ Wear long-sleeved clothing and gloves.
Fig. 46 Change the oil filter
1
Engine block
2
Oil filter
3
Direction of rotation to unscrew the filter
1. Open the left-hand door.
2. Prepare a receptacle.
3. Use a filter wrench to loosen and unscrew the filter. Catch any escaping oil.
4. Carefully clean sealing surfaces using lint-free cloth.
5. Lightly oil the new filter's gasket.
6. Turn the oil filter clockwise by hand to tighten.
7. Check the engine oil level.
Low oil level: Replenish engine oil.
8. Reconnect the negative battery terminal.
9. Close the door.
Dispose of old oil filter, old oil and materials contaminated with oil according to environmental
protection regulations.
10 Maintenance
10.3 Engine maintenance
114
Operator manual Portable compressor
M 64
No.: 9_5898 26 E
RAMIRENT
