5. Insert a new filter element.
Wear gloves!
6. Screw on the filter housing clockwise.
Putting in operation:
1. Screw the condensate drain hoses to the housings of the pre-filter and the micro-filter.
2. Close the condensate drain shut-off valves.
3. Tighten the filter combination fittings.
4. Turn on the «battery isolating switch».
5. Close the door.
Dispose of old parts and contaminated materials according to environmental regulations.
Further information Further information on changing elements can be found in the filter instructions in chapter 13.6.
Starting the machine and performing a test run:
1. Switch the machine on and run it in IDLE mode for approx. 5 minutes.
2. Shut down the machine.
3. Wait until the machine has automatically vented.
Pressure gauge reads 0 bar!
4. Open the outlet valves.
5. Open the left-hand door.
6. Check the combination filter housing and hose lines for leaks.
7. Close the door.
10.7.4 Option dc
Fresh air filter maintenance
Before commencing work on the fresh air filter, read and understand the operating instructions giv‐
en in chapter 13.7.
Precondition The machine is shut down.
The machine is standing level.
The machine is fully vented, the pressure gauge reads 0 bar.
All compressed air consumers are disconnected and the air outlet valves are open.
10 Maintenance
10.7 Maintenance of Optional Items
146
Operator manual Portable compressor
M 64
No.: 9_5898 26 E
RAMIRENT
