-10-
Ɣ')OLS
Ɣ2EVWDFOHDYRLGDQFHVHQVRU
Ɣ$XWR+RYHU
Special Function Button Guide
Ascending the quad copter to 2 meters high, press the 3D flip button(remote
controller will make two sound didi continuously, the sound will stop when
finished the movement ) and then push the right control stick in any direction
at the utmost, the quadcopter will roll over accordingly .
Mount the obstacle avoidance sensor module to the bottom of the drone,
when it detect that there have obstacle within 2m(depend on
environment ), the drone will not keep approaching, it will avoid the
obstacle automatically. The module will work automatically when it fly 80-
100cm away from ground. This function can decrease the crash percentage,
but please do not use human being or object as testing reference to avoid any
danger happen.
Push the throttle up slightly and release it, the drone will stick to a specific
height steadily.Push the throttle down when decent the drone.
NOTE: The 3D flip function can not work if the drone is mounted with obstacle
avoidance module and camera, make sure take out these two module
before play this function.(You should restart the drone and controller
to auto connect this function)
The 3D function can not work under low power.
2m
2m
2m
2m
Note: Obstacle avoidance function only works under slow speed.Obstacle
avoidance function can not work under glass and black environment,
white wall can achieve its best working status.When the obstacle
avoidance module is working, headless mode and one key to return
function will not work.
