the corresponding functions.
5.Matters needing attention
1
、
Children, the elderly and people with disabilities, please use under supervision;
2
、
Do not plug or unplug any cables while the power is on, it may cause malfunction of the
operation function. If this happens, you can cut off the main power, and then reconnect it
after about 30s to recover;
3
、
When the remote control presses multiple keys at the same time, the system will recognize
them as invalid keys and will not respond, except for special combination keys;
4
、
It is not recommended to operate multiple faders at the same time, except for special
functions;
5
、
Please replace the battery of the controller in time. When not in use for a long time, remove
the battery.
3
/
3
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. This device complies with part 15 of
the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undeundesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates,uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
