Breeze Away function( ) (some units) :
Sleep function( ) :
AP function( )(some units) :
Follow me function( ):
SET function
or
SET
SET
OK
Press the SET button to enter the function
setting, then press SET
button or TEMP or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the
OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET
button to scroll through operation functions as follows:
Breeze Away ( ) Fresh ( ) Sleep( ) Follow Me( ) AP mode( )
[ ]: If your remote controller has Breeze Away button or Fresh button, you can not use the SET
button to select the Breeze Away or Fresh feature.
*
*
*
The FOLLOW ME function enables the remote
control to measure the temperature at its
current location and send this signal to the
air conditioner every 3 minutes interval.
When using AUTO, COOL or HEAT modes,
measuring ambient temperature from the
remote control(instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around you and
ensure maximum comfort.
The SLEEP function is used to decrease
energy use while you sleep (and don t need
the same temperature settings to stay
comfortable). This function can only be
activated via remote control.
Note:
The SLEEP function is not available
in FAN or DRY mode.
,
For the detail, see sleep operation in
USER S MANUAL.
,
,,
,,
,,
,,
This feature avoids direct air flow blowing on the
body and makes you feel indulging in silky
coolness.
NTOE:
This feature is available under cool,
Fan and Dry mode only.
FRESH function( ) (some units) :
When the FRESH function is initiated, the
Ionizer/Plasma Dust Collector
or UV lamp
(depending on models) is energized and will
help to remove pollen and impurities
from the air.
,
,
,
,
,
,
,
,
If the memory feature is stopped,
OF
displays for 3 seconds on the screen.
While the memory feature is activated,
press the ON/OFF button, shift the mode
or power failure will not cancel the Follow
me function.
NOTE:
Press and hold Boost button for
seven seconds to start/stop memory
feature of Follow Me function.
If the memory feature is activated,
On
displays for 3 seconds on the screen.
Choose AP mode to do wireless network
configuration. For some units, it doesn’t
work by pressing the SET button. To enter
the AP mode, continuously press the LED
button seven times in 10 seconds.
EN
64
Summary of Contents for KCD-24
Page 49: ...kaisai com ...
