Kaiser Baas THETA, User Manual

EN

THETA 

DRONE

| User Guide

24

FAQ

Q1. THE DRONE LED LIGHTS ARE FLASHING. WHAT DOES THIS MEAN?

A1. The Drone is not paired with a Transmitter. Refer to the Drone Setup/Installation 
section.
A2. The Drone has insufficient battery power. Please charge the Drone battery.

Q2. THE DRONE’S ROTOR BLADES SPIN BUT THE DRONE DOES NOT TAKE-OFF?

A1. Insufficient Battery Power. If the Drone LEDs are flashing and the Drone Rotor Blades 
are spinning without any lift, recharge the Drone Battery.
A2. The Rotor Blades are distorted. Replace them with only official Kaiser Baas 
replacement blades.

Q3. WHY IS THE DRONE IS SHAKING AND NOT STABLE IN FLIGHT?

A1. Please check to ensure the Rotor Blades are not damaged. Refer to the maintenance 
guide on Rotor Blade care.
A2. Check that all the motors are spinning. Refer to the maintenance guide for more 
information. 

Q4. MY DRONE KEEPS TIPPING WHEN I TAKE-OFF!

A1. It is often difficult for new Pilots to get used to the take-off procedure. To take-off 
without tipping, give the Drone a smooth lift of power with the Throttle, rather than a 
quick movement. Once in the air, keep the Drone level using the Right Stick (Elevator/
Aileron).

Q5. THE DRONE IS OUT OF CONTROL AND IS DIFFICULT TO FLY. HOW CAN I MAKE IT EASIER?

A1. Prior to every flight we recommend you calibrate the Drone. To calibrate push the 
Left Throttle/Yaw Stick and the Right Pitch/Roll Stick to the bottom left and hold for 
2 seconds until you see the LED indicator lights on the drone start to flash rapidly. The 
Drone LEDS will stop flashing when calibration is complete.