20
EN
MULTIFUNKTION OVEN CONTROL
Oven operation functions are controlled by the
knob
1
operation mode
and knob
2
temperature controls
set up on the control panel.
The graphic symbols on the knobes indicate the
selected operation modes.
To switch off the oven, set up the knob
1
operating mode
and the knob
2
temperature
control
in position „0“.
For more comfort, you can use the
electronic
programmable control
4
, which enables to run
the oven in automatical, half automatical or
manual cycle.
After the selected oven temperature has been
achieved, the red control light goes out.
If it is necessary to put the dish into a pre-heated
oven, do it after the red control light has gone out.
The red control light can also be on if the knob is
set in the position to illuminate the oven. In this
position, however, the heating element of the oven
is off.
If the control panel of your oven is equipped with
sunk knobes
Push
, to control the heat supply:
x
Push the knob slightly and let it go
The knob will come out of the control panel.
To countersink the knob:
x
Push the knob as far as it will go and let it
go.
* for models with control electronic programmable control
and programmer
Important!
The activation of the oven is
indicated by yellow
3
and red
5
control
lights.
3
4
5
2
1
1
2
