KRSL series
Page
36
6.6 MAINTENANCE SCHEDULE
This Schedule is intended to be used as a guideline only. Depending on the specific operating
conditions of your KRSL compressor, maintenance requirements may vary. The instructions in
this section will give more details about determining when specific service should be performed.
First 500 hours
Change fluid filter and check fluid level
Every 500 hours
Drain water from air/oil separator tank.
Check fluid level
Clean air filter
Clean after-cooler fins.
Check for loose fluid and air tubing, electrical wiring
connection.
Every 1000 hours
Clean air filter or replace with new element.
Clean after-cooler fins.
Every 2000 hours
Check fluid level.
Check safety valve
Replace fluid filter.
Perform fluid sampling
Every 4000 hours
Clean after-cooler fins.
Check fluid level.
Replace air filter.
Every 8000 hours
Check equipment power supply and earth-grounding.
Replace air/oil separator.
Replace fluid.
Troubleshooting Guide
Information below is a troubleshooting guideline; it describes symptoms and possible cause. Do
not assume that these are the only faulty condition that may occur.
