B Mode Ultrasonic Scanner
User’s Manual V1.00
- 10 -
Chapter 5
System Check
5.1 Place equipment
Please carefully read through and fully understand the safety cautions before moving and placing
the equipment.
1. Unpack the equipment case and check the goods for its completeness according to the packing
list.
2. Place the equipment on a stable and leveled position.
5.2 Check the equipment before and after use
1. Before and after ultrasonic diagnosis to check if there are any exceptionally on the acoustic lens,
such as peeling, cracks, bulge, or if the acoustic lens is reliable, disinfected or cleaned.
2. Check the equipment to ensure a normal start-up: whether the display shows the battery charge
indication and wireless network identification, and no abnormal voice, strange smell or
overheating.
3. Check the acoustic lens for abnormal heat when the equipment is in use. You can touch the probe
by hand to feel its temperature.
4. Check the image to ensure trouble-free display (no abnormal noise or flicker).
5.3 System reset
In case of abnormal screen display or no-working for system operation, try to restart the system by
turning on/off the power.
5.4 Charge the equipment
Charge the equipment with the included USB charger on the phone/Pad or portable charger. The
specifications for the charger is 5.0V, 2.0-3.0A.
Equipment can be used for about 2 hours after fully charged; the shortest charging time is 3.5-4
hours, up to 4.5 hours; Over-charging or discharging will shorten the battery life.
Attention
: Thoroughly clean the coupling gel on the probe surface each time after
ultrasonic operation, or the coupling gel may become hardened on the acoustic lens of the
probe, deteriorating quality of image.
Warning:
The waterproof grade of the equipment is IPX4 (no adverse effect on
splashing water in all directions). Splash any liquid on the equipment may damage it. If
you accidentally splash liquid on the equipment, please immediately turn off the power
and contact your service representative.
Attention:
If the overheat acoustic lens is placed on the patient’s skin, heat injury may
occur.
Warning:
1. When the equipment works abnormally, do stop working, turn off the power and check
the reason, then contacts the KAIXIN Company about it.
2. Turn off power after ultrasonic diagnostic operation.