1. USES
This machine is used for shearing and bending low carbon plate (mild steel) or the other
metal materials which have the same intensity as the low carbon plate, but the maximum
thickness is 1.5 mm. It can also be used for rolling the low carbon plate (mild steel) or the
other metal materials which has the same intensity as the low carbon plate, its maximum
thickness is 1.5 mm.
2.
USES AND MAINTENANCE
2.1 Before using this kind of machine tool, in order to have an intimate knowledge of
structures of the machine tool, and the function of the handle, drive and lubrication systems,
you must read this direction first.
2.2 Whatever the working condition is, in order to avoid slide of the machine tool, this kind
of machine must be fixed on the ground or special machine seat.
2.3 Please firmly execute the following operating rule:
2.3.1 Before packing this machine tool
，
antirusting agents are put on it,. So when you want
to get rid of the kind of rust inhibitor, you don’t have to install the yellow coat with varnish diluent
and paint flux for machine oil.
2.3.2 Please keep the machine clean, and materials which avoid slide can be used in this
area.
2.3.3 When you move, install, clean and adjust the machine tool, please keep your hand
away from the shears.
2.3.4 Close the protecting cover when you don’t use the sliding roll of the machine.
2.3.5 Keep your hands away from the die when you are working.
2.3.6 Operators must be familiar with the structure and function of this machine. Protecting
mask and the other safety devices should be used when working.
2.3.7 Focus your attention on the machine when someone near the machine.
2.3.8 Any metal plate that thickness and quality goes beyond the demands scope is
unaccepted.
2.4 Generally the operating handle was installed on the right side of the machine tool (left
is also acceptable).
2.5 Back-measure plate (Angle iron)
Back-measure plate is used for shearing and bending when the machine is under the
condition of working. Please screw two long bars into the nut of concave mould plate, ensure
that the bars pass through the front part of the concave mould plate. Tighten up the nut, then
back-measure plate and concave mould plate can move up and down.
When it is in the place of shearing condition, before putting the bars into the positioning
