5
The machine is resting on 2 cardboard blocks (1 at each end). These blocks have to be removed. Lift up the
machine slightly to remove them.
Roll the machine slowly down to the floor on the ramp. For this step, two persons are required to
guide and keep the machine straight.
Finally, place the machine at the required location in your premises.
2. CAUTION WHEN PLUGGING THE MACHINE TO THE POWER
2.1. Electrical power requirement
Before connecting the machine to the power, check that :
-
Your machine’s tension corresponds with the tension of your electrical network.
-
The electrical connection requires a plug compatible with CEI 60309-1.
-
The electrical connection should comply with installation norm NFC 15 100.
2.2. Installation
-
Install the laminator on a flat floor, next to an easily accessible plug.
-
Do not touch the socket with damp hands.
-
To unplug the machine, disconnect the plug without pulling on the supply lead.
-
To prevent electric shocks, do not use this laminating machine close to water.
-
Leave a large enough working area behind the machine.
-
Do not spill water on the machine, the supply lead or the electric socket.
-
Do not use the machine if the supply lead is damaged.
-
Do not leave the electric lead in contact with a warm surface.
-
The machine should be installed in a well-ventilated place.
-
Do not use extension cord with a small diameter section not corresponding to the power of the
machine
-
Do not plug to a multi-socket plug
2.3. Safety
The laminator has got 3 safety mechanisms that would immediately stop the rotation of the
laminating rollers.
- A laser protection (p) : located on the right side of the machine, next to the roller, it detects
any obstacle (hand or other) that may shut off the laser ray.
- 2 emergency stop buttons : easily reachable, one on the front right hand side and one on
the rear right hand side. The use of one of these emergency stop buttons would switch off
instantly the rotation of the heating drum.
- The feeding tray (n) : safety is activated when the feeding tray is up and not in the working
position.
!!! CAUTION !!!
Laser ray. Do not watch this
ray directly. Laser product
rated in class 2
