USER MANUAL STARTER
19
TRANSLATED FROM ORIGINAL VERSION: EDITION 1
6. APPLICATIONS
6.3 Mounting onto rigid boards
7.
To avoid the application tape to stick
onto the lower roller, run a vinyl width of
the same size or wider than the
application tape.
8.
Lower the upper roller (refer to § 5.3)
and adjust pressure based on the width
of the print and regarding our pressure
adjustment recommendations (refer to
§ 7.1).
1.
On the adhesive back side of the print,
remove a stripe of protection paper on a
width of about 5 cm and fold it.
2.
Position the print (Rep. 1) on the
board and stick manually the stripe onto
the board (Rep. 3).
Tear off slightly part of the release paper
from the back of the print. (Rep. 2).
