KALAMAZOO
INDUSTRIES, INC.
KALAMAZOO, MI
PH: (269) 382-2050
www.kalamazooind.com
KI
INSTRUCTIONS CONTINUED
Sanding head position: sanding head can be positioned from vertical to horizontal with any angle in between.
Loosen 5/16” socket head cap screws located above and below coupling
(28)
in base
(1)
while holding sander
head firmly. Sanding head/frame is locked in position be squeezing bearing houseing assembly against base.
When desire position is reached, tighten 5/16” cap screws to lock in sanding head.
CAUTION: SANDING
HEAD IS VERY HEAVY. SUPPORT THE SANDING HEAD WHEN LOOSING CAP SCREWS.
Platen: the platen is located behind sanding belt. The platen can be reversed and flipped to give four sanding
areas. Normal wear will occur and platen will need to be rotated occasionally depending on usage. Remove
sanding belt and platen screws
(23)
to rotate platen to new position.
NOTE: CONTINOUS SANDING ON THE SAME SIDE OF PLATEN WILL RESULT IN
PREMATURE PLATEN WEAR AND BELT BREAKAGE WILL OCCUR. MOVE WORK PIECE
TO DIFFERENT AREAS OF PLATEN TO EXTEND PLATEN AND BELT LIFE.
Worktable: the worktable has a slot for mounting fixtures and or a mitre gauge. Also, two mounting holes are
provided on the side of the frame
(7)
to move the work table to different work heights
NOTE: KEEP THE WORK TABLE WITH A 1/8TH GAP BETWEEN THE TABLE AND THE
SANDING BELT.
DUST COLLECTOR
Clean out dust collector after every shift and don’t mix materials.
