0150-0238B
5-5
Kalatel DSR-1000eZ
Use this menu to configure the Ethernet communications settings. Select from the
following:
Hostname:
Not selectable. Pulled from the systems serial number.
Ethernet:
Select Enable or Disable.
DHCP:
Select Enable or Disable. Enables dynamic IP addressing. When DHCP is enabled, the IP
address, Subnet Mask, Gateway, and Server fields are dynamically addressed.
Name Service:
Select from Disable or WINS. Enabling WINS registers the hostname and IP address
within the current Network. This ensures that you can connect to the DSR by hostname within the
network.
IP Address / Subnet Mask / Gateway:
Consult with a qualified Network Administrator or an MIS
professional to configure these settings if DHCP is not enabled.
Primary Name Server / Backup Name Server:
The IP addresses of the Primary and Backup Name
Servers. Not required if DHCP is enabled.
Print Server:
Enter the Print Servers IP address to enable the Print Image operation (Function and
Zoom).
TCP MTU Size:
Select from Standard, 1400, and 1200. The MTU describes the maximum possible TCP
packet size. Standard (1500) is optimal for most ethernet network environments.
Ethernet Settings
[CANCEL] [OK]
Hostname : V201F04310209
Ethernet :
DHCP : Disable
Name Service : Disable
IP Address
Subnet Mask : 255.255.254. 0
Gateway
Primary Name Server : 3. 18.173. 12
Backup Name Server : 3. 18.173. 13
: 3. 18.173. 60
: 3. 18.172. 1
TCP MTU Size : Standard
Enable
How the unit handles an Ethernet session
At the start of an Ethernet session, the unit locks out its own front panel and disables all RS-232 and
RS-485 communications. During the Ethernet session, the unit can only be accessed remotely, using
the WaveReader software. When the Ethernet session ends, the unit re-enables the RS-232 and RS-
485 communications and unlocks the front panel.
Playback stops when an Ethernet session is started. Playback will not be re-activated automatically
when the Ethernet session ends.
o
Advanced Menu
→
Communications
→
Modem Settings
The default modem string (shown below) is for use with Hayes Accura 56k, Diamond Supra Express
56k, and 5686 US Robotics modems in their default conditions. Consult with the modem manual
