VI User Manual Groove Pedelec
17
Do not use other chargers. Only charge the battery us-
ing the charger provided, or a charger approved by us.
If a problem occurs, remove the battery from the Pe-
delec and place it briefly in the charger. The charger
tests the battery and corrects any faults that may be
present.
If used incorrectly, the device may be damaged or
inflict injuries.
›
Before cleaning the charger, always pull the plug
out of the socket to avoid a short-circuit and/or
physical injury.
›
Only use the charger in dry rooms.
›
Only place the charger in an upright, secure and
stable position on a suitable surface.
›
Do not cover the charger or place any objects on
it as otherwise it could overheat and catch fire.
9 Removing the front wheel
If you need to remove the front wheel, to repair a punc-
ture for example, this can be done in the same way as
removing the front wheel of a normal bike, excluding one
procedure.
›
The first thing you must do before releasing the
front wheel is to open the connection to the front
wheel motor.
›
Undo the locking nut for the electrical connector
which is located on the back of the fork. Take the up-
per half of the connector in one hand and the lower
half in the other and pull the two halves apart.
1 Locking nut
2 Cable tie
1
2
The lower half of the connector and the power cable are
fastened to the fork with two cable ties.
›
Slide the cable ties down and off the fork. You can
now remove the front wheel. You can find corre-
sponding instructions in the section of this User
Manual that deals with general bike technology. If
you take the front wheel out of the fork, also pull
the cable and cable tie off the fork.
›
To reinstall the front wheel, slide the cable tie
with cable onto the fork leg before positioning the
wheel in the fork. Install the front wheel as de-
scribed in the general section of this User Manual.
›
Next, reattach the two halves of the connector and
screw the lock nut firmly back on. Slide the two ca-
ble ties back up the fork until they remain in place
of their own accord and cannot slip.
Summary of Contents for BionX
