20
Original User Manual | Pedelec Impulse 2.0
7.4.4.3 Miscellaneous
Choose from the following using the / button.
•
Factory settings
•
Software
•
Back
Confirm your selection by tapping the button.
Factory settings:
The following question appears: “Restore
factory settings?”. Select “Yes” if you wish to reset the
system to its original settings. Select “No” if you wish to
retain all the settings you have made previously. Confirm
your selection by tapping the button.
Software:
You are taken to the items:
•
Version
•
Update
•
Back
Make a selection using the / button, confirm and go to
that item by tapping the button.
•
Version: Here the current software version of the
motor is displayed.
•
Update: Here you can bring the software up to
date. Your specialist cycle shop will perform a soft-
ware update.
7.4.5 Personalize
Choose from the following using the / button.
•
Name
•
SET-Favourites
•
Back
Confirm your selection by tapping the button.
Name:
Under the sub-item “Name”, you can enter a name
or some text with a maximum of 21 characters which will
be displayed when the display is turned on and off. Navi-
gate using the / button and select the desired char-
acter. Tap the button briefly then release it. Select the
desired text from the following options:
Wheel circumference:
You can set the “wheel circumfer-
ence” to any value between
1540 mm
and
2330 mm
by
pressing the / buttons on the control panel. Tapping
the button confirms your selection and then takes you
back to the menu sub-item display.
A change to the setting becomes necessary, for ex-
ample, when you have the tyres on your Pedelec
exchanged for some of a different size. In order to
continue to display the correct data, the new wheel
circumference must be entered.
Shift Sensor:
Choose from the following values using the
/ button.
OFF
50 ms 100 ms 150 ms 200 ms 250 ms 300 ms
Confirm your selection by tapping the button.
The Shift Sensor recognises gear shifting and imper-
ceptibly interrupts the power assist for fractions of a
second. This enables you to move more smoothly and
considerably faster through the gears. The higher the
value you set, the longer the assistance is interrupted
for, and the more time there is for shifting gears.
Climb Assist:
Choose from the following values using the
/ button.
1
2
3
4
5
6
7
Confirm your selection using the button.
You can influence the response time of the power sen-
sor with the Climb Assist. The lower the value you set,
the less responsive the system becomes. The higher
the value you set, the more dynamic the system be-
comes, but beware a yo-yo effect.
Summary of Contents for Bosch Active Line
