OFF
：
The set would enter standby mode
after 15 minutes without input
2-WARM UP
OFF
signal
；
OK
ON
：
Aging mode. Aging time will
display on the left bottom of screen.
3-ADC
ADC calibration
（
refer as follow
）
OK
4-WHITE BALANCE
White Balance data adjustment
（
refer OK
as follow
）
The balance data is set by PE before
the mass production. Do not need
adjust.
5-SHOP
DO
Reset the set after production
OK
alignment;(This
operation
will
remove all unnecessary factory value;
The factory hotkey will be turn off)
6-NVM reset
DO
System initialization. Restore all
OK
data except the White Balance and ADC
data ;Only for R&D.
7-SET FAC CH
DO
Preset specific factory channels for OK
specific factory. Press left and
right button to select the factory,
and then press OK to confirm.
8-POWER ON
LAST
ON: Always turns on TV when AC power OK
on
STB
：
Always goes to standby mode when
AC power on
LAST
：
Restore the status before the
last AC power off
9-USB UPDATE
USB update
，（
refer as follow
）
OK
10
This item only factory used
，
ReloadEFBItem…
Note: Below the factory menu, some model information are showed, including
software version, Project Name, SIACP Version, and SW release time.
ADC Submenu:
ITEMS
Default
Description
Status
Setting
Summary of Contents for K-LED32HDXDT2
