IMPORTANT SAFETY INSTRUCTIONS
Read before operating equipment
1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Do not use this apparatus near water.
6.
Clean only with a dry cloth.
7.
Do not block any of the ventilation openings. Install in
accordance with the manufacturer
'
s instructions.
8.
Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9.
Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding type plug has two
blades and a third groundingprong. The wide blade or third
prong are provided for your safety.
When the provided plug does not fit into your outlet, consult
anelectrician for replacement of the obsolete outlet.
10.
Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11.
Only use attachments/accessories specified by the manu-
facturer.
12.
Use only with a cart, stand, tripod, bracket, or table
specified by the manufacturer or sold with the app
-aratus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid
injury from tip-over.
13.
Unplug this apparatus during lightning storms or when
unused for long periods of time.
14.
Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in any
way, such as if the power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the app
-aratus, or if the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
15.
This product may contain lead and mercury. Disposal of
these materials may be regulated due to environmental
considerations. For disposal or recycling information, please
contact your local authorities or the Electronic Industries
Alliance (www.eiae.org).
B.
Objects have fallen or liquid has been spilled into the
appliance;
C.
The appliance has been exposed to rain;
D.
The appliance does not appear to operate normally or
exhibits a marked change in performance;
E.
The appliance has been dropped or the enclosure
damaged.
17.Tilt/Stability
- All televisions must comply with recomm-
ended international global safety standards for tilt and
stability properties of its cabinet design.
•
Do not compromise these design standards by applying
excessive pull force to the front, or top, of the cabinet,
which could ultimately overturn the product.
•
Also, do not endanger yourself, or children, by placing
electronic equipment/toys on the top of the cabinet. Such
items could unsuspectingly fall from the top of the set and
cause product damage and/or personal injury.
18.Wall or Ceiling Mounting
- The appliance should be
mounted to a wall or ceiling only as recommended by
the manufacturer.
19.Power Lines
- An outdoor antenna should be located
away from power lines.
20.Outdoor Antenna Grounding
- If an outside antenna is
connected to the receiver, be sure the antenna system is
grounded so as to provide some protection against voltage
surges and built up static charges.
Section 810 of the National Electrical Code, ANSI/NFPA
No. 70-1984, provides information with respect to proper
grounding of the mast and supporting structure, ground
-ing of the lead-in wire to an antenna discharge unit, size
of grounding connectors, location of antenna-discharge
unit, connection to grounding electrodes, and require-
ments for the grounding electrode. See Figure below.
21.Object and Liquid Entry
- Care should be taken so that
objects do not fall and liquids are not spilled into the en-
closure through openings.
22.Battery usage CAUTION
- To prevent battery leakage
that may result in bodily injury, property damage, or
damage to the unit:
•
Install all batteries correctly, with + and - aligned as
marked on the unit.
•
Do not mix batteries (old and new or carbon and alkaline,
etc.).
•
Remove batteries when the unit is not used for a long time.
23.
Apparatus shall not be exposed to dripping or splashing
and no objects filled with liquids, such as vases, shall be
placed on the apparatus.
Example of Antenna Grounding
as per NEC - National Electrical Code
Note to the Cable TV system installer:
This reminder is provided to call the Cable TV system installer
'
s attention to Article
820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be
connected to the grounding system of the building, as close to the point of cable entry as practical.
1
16.Damage Requiring Service
- The appliance should be
serviced by qualified service personnel when:
A.
The power supply cord or the plug has been damaged;
