INSTALLATION INSTRUCTIONS
Deck-Mounted Bath Set
1144944_2_A
3 of 5
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
PRePARe FOR SPOUT INSTALLATION
2.
Rough
Deck
Tile
1-1/2” (3.8 cm)
Remove the plaster guard from the spout supply tube.
Cut off the spout supply tube 1-1/2” (3.8 cm) above the rim,
finished deck, or tile.
Remove all burrs from the supply tube to prevent damage to the
O-ring seal.
INSTALL The SLeeVe
3.
Spout Supply Tube
Setscrews
Sleeve
Washer
Spacer
CAUTION: Risk of product damage.
Use care when installing the
spout assembly to prevent damage to the O-ring seal.
ImPORTANT! Keep the spout supply tube clean above the finished deck to
avoid damage to the O-ring seal.
NOTe: The washer is not needed for rim/finished deck installation.
If the installation includes a tile covered rough deck, slide the washer,
flat side facing forward, onto the supply tube.
If a spacer is provided, slide the spacer onto the supply tube.
Loosen the setscrews in the sleeve.
Use a twisting motion to install the sleeve on the spout supply tube
until it contacts the deck or washer, or spacer.
Align the sleeve with the setscrews offset from the center (not facing
directly forward or backward) of the supply tube.
