Programming the Remote Control (cont.)
On the user keypad, press the up arrow, down arrow and the “OK” button simultaneously. The
bottom LED, on the keypads indicator bar, will begin flashing.
While the LED is flashing, press the “OK” button on the keypad. A light sequence will illuminate
up and down the indicator bar.
While the indicator bar light sequence is active, press any button on the remote control. The
program will download and the user keypad will darken. The user keypad will now respond only
to this remote control.
Care and Cleaning Instructions
Cleaning Your Cast Iron Whirlpool
Rinse the whirlpool thoroughly after each use and use a soft cloth to wipe it dry. If the surface
becomes dirty, use a general purpose cleaner such as Scrub Free
®
Mildew Stain Remover, Clorox
Clean-Up
®
, Glass Plus
®
, Winde Original, Fantastic
®
All Purpose, Mr. Clean Top Job, Formula 409
®
All Purpose, Lysol
®
Basin, Tub and Tile Cleaner or Scrubbing Bubbles
®
Bathroom Cleaner.
IMPORTANT!
Use water soluble cleaners (dissolve 100% in water). Cream-based cleaners may have a
tendency to build up, reducing the friction on slip-resistant surfaces.
Express Bathroom Cleaner may be used on the Safeguard surface of your whirlpool. It is not sold
commercially. Call 1-800-470-8337 to order. You may use a soft nylon brush on the Safeguard
surface.
Do not use steel wool, wire brushes or abrasive sponge pads. In the rare occurence of stubborn
stains, use abrasives or abrasive cleaners sparingly, but not on the Safeguard surface on the bottom
of the whirlpool.
For occasional rust removal you may use Whink
®
Rust and Iron Stain Remover or Muriatic Acid.
Cleaning Your User Keypad and Remote Control
Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty,
use a non-abrasive soap and warm water to clean.
Flushing Your Whirlpool System
Flush your whirlpool system twice a month or more, depending upon usage. Use the following sequence:
Turn the jet trim rings fully clockwise to remove air induction.
Fill the whirlpool with warm water to a level at least 2
″
(5 cm) above the highest jets, or leave water
in the whirlpool after using.
Add 2 tablespoons (30 ml) of a low-foaming dishwasher detergent and 20 ounces (590 ml) of
household bleach (5% - 6% sodium hypochlorite) to the water.
Run the whirlpool for 5 to 10 minutes. Turn off the whirlpool and drain.
If desired, rinse the bath surfaces with water.
Rinse the surfaces of the jets, faucet, handrails, drain, etc. and wipe them dry with a soft cloth.
Limited Five-Year Warranty
Kallista warrants that its products conform to the relevant published specifications, and are free of defects in
workmanship or materials during normal residential use.
Kallista warrants, for a period of five years from the date of purchase from Kallista, that it will replace or
repair any product, with the exception of product within the Kallista Hampstead and Stafford Vitreous line,
1019455-5-B
6
Kallista
