HOMEOWNERS GUIDE
Bath with Airjets
1096755-5-
D
5 of 16
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
USER KEYPAD AND BATH WITH AIRJETS MODES/FEATURES
Rotating Ring Key Pad
Purge Mode
Decrease Flow or Surge
Indicator Bar
Increase Flow or Surge
Surge Mode
Zone 3
Power On/Off
Zone 1
Air Flow Mode
Activates Mode Selected
Zone 2
Rotate outer ring to
access desired mode.
Power On/Off -
Turns the blower motor on and off. Symbols illuminated in blue indicate available modes/
features. Modes which are operating will display in green.
Activate Button -
Press “OK” to activate the desired mode. The active mode will
fl
ash (green).
Up Arrow -
Increases the air
fl
ow when the air
fl
ow mode is active. Increases the pulse speed when the
surge mode is active.
Down Arrow -
Decreases the air
fl
ow when the air
fl
ow mode is active. Decreases the pulse speed when
the surge mode is active.
Outer Ring -
Rotate the outer ring to the desired mode. The selected mode will
fl
ash (blue).
Indicator Bar -
Shows the air
fl
ow volume when operating in the air
fl
ow mode. Shows the surge speed
when operating in the surge mode.
Purge Mode -
Select to initiate the purge mode manually. The purge cycle will not start if there is water in
the bath. The purge mode blows any residual water out of the air channels. The blower motor starts and
runs at a low speed for about two minutes. An automatic purge cycle occurs when the bath is drained and
the water level falls below the level sensors.
Air Flow Mode -
In this mode, air
fl
ow is directed through any combination of the airjets in the selected
zones. Air
fl
ow can be adjusted with the arrow buttons. When the surge mode is selected, the air
fl
ow mode
stops. When the air
fl
ow mode is selected while operating in the surge mode, the surge mode stops.
Zone 1 -
This mode is used to select or deselect the air
fl
ow through Zone 1.
Zone 2 -
This mode is used to select or deselect the air
fl
ow through Zone 2.
Zone 3 -
This mode is used to select or deselect the air
fl
ow through Zone 3.
Surge Mode -
When active, the air
fl
ow ramps up from minimum to maximum and then down again to
minimum. The surge speed is adjustable between 10 seconds to 60 seconds by using the up or down
buttons. The up and down arrow buttons can be used to adjust the surge speed. Zones can be selected or
deselected when in the surge mode.